Rotary Drilling Rig Transport Precautions

1.During the transportation process, it is strictly prohibited to carry any personnel or other items in the driving room of the rotary drilling rig, and it is strictly prohibited to transport people and machines mixed.

2. Before transportation, corresponding measures must be taken to tighten the leash, so as to avoid dangerous accidents that fall off during transportation.

3. During the loading and unloading process of rotary drilling rig, personnel and items that hinder loading and unloading are strictly prohibited within the range of lifting and lifting arm activities.

4. Around the rotating excavator being loaded and unloaded, there shall be no idle personnel and other articles that hinder the loading and unloading.

5. In addition to being lifted or driven directly from the dock, the rotary drilling rig can also use two plates of sufficient strength to mount the transport vehicle (plate). The tilt Angle of the plate is less than 15 degrees, the slope is 3.5 times the height, and the plate is 1.3 times the width of the track.

6. Before moving up and down the guide rails, lower the positioning handle of the rotating platform to prevent the platform from rotating. When running on the upper and glide paths, other handles shall not load and unload equipment on a solid and flat surface.

7.To set the anti-rear-end light prompt, set the slow driving sign yourself.

8.Because there are teeth on the track, it is easy to cause noise and damage the road level on the road, so there are restrictions on driving, therefore, do not drive on public sections, you should choose to check

END